Basement water problems is a major concern for many homeowners.

While waterproofing your basement may seem expensive and even unnecessary at first, keep in mind that in most cases repairing water damage will cost more than waterproofing your basement.

Waterproofing your home's foundation is the best way to prevent water from entering your basement.

Basement waterproofing is divided into two main areas: internal foundation waterproofing and external foundation waterproofing.

Install Proper Gutters and Downspouts

What most homeowners don't realize is that the largest waterproofing system for a home is the roof, gutters, and down spouts.

So, the first thing you need to do is check your roof drainage system for cracks, holes, or gaps in the seams or lining.

You should also check for blockages on leaves, twigs, or other debris that might "hinder your work."

Correct Any Ground Slope Problems

The ground surrounding the foundation walls should always extend at least four to five meters, using a minimum of 10 degrees or more.

This ensures that any surface water flowing along the top will not accumulate or sink into the basement.

Installation of an External Drainage System

This type of waterproofing system requires the floor next to the outer walls of the foundation to be removed and a slab or membrane and a drain pipe installed on the walls.

The area can then be re-filled with soil, sand, or pea gravel.

Many American experts consider waterproofing as one of the most effective methods for solving external problems, as well as the most expensive.

Internal Drainage Channel Above the Concrete Floor

With this approach, the drainage channel is installed inside the foundation, at the base of the foundation wall, above the floor.

This method does not really solve the problem of water infiltration, but only allows water to be redirected from the bottom of the walls into the drain or into the bathroom.

Internal Drainage Channel Level with the Concrete Floor

With this waterproofing solution, you need to remove the concrete floor along the base of the foundation and install a drainage system.

The channel goes to a drainpipe to go to a drain or drain channel. If the base is made of sieve or stone blocks, holes must be drilled in the core to drain the blocks completely.

Internal Drainage Systems Under The Concrete Floor

This type of waterproofing is considered by many American waterproofing companies as the best method for indoor applications.

It requires you to dig a concrete floor and install an underground gravel and drainage pipe system so that all the water can flow down. and be taken out of the basement. walls.

However, this system leaves your basement drier.

Crack Repair

If you want a dry basement, it's important not to leave cracks open.

Some of the cracks that are visible inside the basement often run through the foundation to show the outside.

All cracks and inconsistencies in the foundation wall must be repaired before the surface becomes watertight.

Seal The Foundation Walls

Sealing your home's foundation wall with a good waterproofing material is the best way to prevent water leaks.

The coating of these materials tends to fade over time, so it is important to regularly check the exterior walls for replacement.

Conclusion

Each of these basement waterproofing solutions as well as other cost-effective methods is used by basement waterproofing contractors.

The professional you hire will pick the best option based on your downside issue that is causing the moisture.